Pinball LEDS by DRAPL 

__________________________________________

DRAPsicle

_____________________________________________

If you are upgrading the insert lighting on early Bally/Stern pinball machines, look no further than The DRAPsicle. These are a permanent solution that resolves flaky socket woes, and provides LED lighting without the need for additional adapters, resistors, or upgraded driver boards.

Installation is easy: simply remove the old socket and slide the stick under the original braided wire, use the original screw to secure, solder the two wires to the pads and forget about it forever. No more flicker and no more dim bulbs... just bright, solid light! Want to use your original lamp driver board? No problem!

(Note: These will NOT work with the Bally 6803 machines, nor will they work in machines with a lighting matrix, for instance a Williams "Firepower" etc.)

NOTE: Keep in mind that these aren't well suited for backbox controlled lamps, so if you decide to add LED bulbs to those bayonet style sockets with an original board, you may need to add additional resistance to remove the flicker in the backbox. This will in no way affect the DRAPsicle installed under the playfield.

*This product requires soldering

*Warm White is similar to our Sunlight White